Risco-group GT480 User Manual download pdf (Page 8)

Fig. 2 Wiring Single Contact

Fig. 3 Wiring Double Contact (on the same zone)

Wiring Passive Infra-Red Detectors

It is essential when using Passive Infra-Red Detectors that you refer to the manufacturers

instruction as to the positioning and settings of the detector. This section is intended as a

guide to the wiring of the detectors.

Fig. 4 Wiring Single PIR

Note: Both detectors must be run on a single cable

from the Control Panel to the first detector

then the second. The 2K2 resistor must be in the

last/final detector.

Zone

12V

D1 D 2

3K3

2K2

5K6

Alarm N/C Tamper N/C

1st Detector 2nd Detector

+ Power -

Alarm N/C Tamper N/C+ Power -

RKP

0V D1

Zone

12V D2

5K6

2K2

3K3

2nd Detector Door Contact

Alarm N/C Tamper N/C+ Power -

RKP

Alarm

Notes

Positions of terminals will vary

according to make.

All PIR wiring diagrams apply

also to Dual Technology

Detectors and Vibration sensors.

Fig. 5 Keypad Zones (480 RKP Only)

Note: Keypad zones (480

RKP Only) are preset

and cannot be changed.

E/E - 3K3 KP Zone 1

Access - 5K6 KP Zone 2

EOL - 2K2

GardTec 480 ENG PR5832 Rev 115IN480IM B A5booklet.qxd 18/07/2007 20:35 Page 5

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Risco-group GT480 User Manual Page 8

Comments to this Manuals

Related products and manuals for Control panel Risco-group GT480