Risco-group 2-Button Panic Keyfob , 2-way User Manual download pdf

ENGLISH

FRANÇAIS

Introduction

The Agility 2-Way remote control is an 8 button rolling code wireless transmitter designed

for remote system operation. The remote control is typically used to set (arm), unset (disarm),

activate devices and get system status. Being bi-directional enables each command that is

sent to the panel to receive a reply status from the panel and indicate the status to the user

via the colour LEDs. For higher security, commands can be de¿ned to be activated with a

4 digit PIN code.

Check with your installer regarding the de¿nitions of the remote control.

* If the 1

LED changes to orange it indicates a low battery condition.

For full installation instructions refer to our website www.riscogroup.com

Common Operations:

Tel: +44-161-655-5500

[email protected]

U.S.A

Tel: +1-631-719-4400

[email protected]

ITALY

Tel: +39-02-66590054

[email protected]

BRAZIL

Tel: +1-866-969-5111

[email protected]

SPAIN

Tel: +34-91-490-2133

[email protected]

CHINA

Tel: +86-21-52-39-0066

[email protected]

FRANCE

Tel: +33-164-73-28-50

[email protected]

POLAND

Tel: +48-22-500-28-40

[email protected]

BELGIUM

Tel: +32-2522-7622

[email protected]

ISRAEL

Tel: +972-3-963-7777

[email protected]

RISCO Group Limited Warranty

ESPAÑOL

Operation Quick High Security Mode

Set (Full) (Away Arm) > Code

Set (Partial) (Stay Arm)* > Code

Unset (Full Disarm) > Code

System Status

for 2 seconds for 2 seconds > Code

Output control A/B/C

/ / / /

for 2 seconds for 2 seconds > Code

Panic Alarm + simultaneously for 2 seconds

Clear Operation >

Introduction

La télécommande bidirectionnelle de l’Agility est un transmetteur 8 boutons à codes tournants

conçue pour commander le système à distance. Elle est utilisée pour armer, désarmer, activer

des périphériques et obtenir l’état du système. Le fait d’être bidirectionnelle lui permet, pour

chaque exécution de commande envoyée à la centrale, de recevoir un retour sur le statut de

la centrale, et de l’af¿cher via la couleur des LEDs. Pour une plus grande sécurité, les

commandes peuvent être dé¿nies pour n’être activées qu’avec un code PIN à 4 chiffres.

Demandez à votre installateur les options de votre télécommande.

Status LED Indications:

Operation 1

LED* 2

LED*

(Send command) (Receive Status)

Full Setting (Away) Green Red

Part Set (Stay Arm) Green Orange

Unset (Disarm) Green Green

Alarm Green Flash LED

Introducción

El mando bidireccional de la Agility es un transmisor vía radio de 8 botones de código

variable (“rolling code”) diseñado para manejar el sistema remotamente. El mando

normalmente se usa para armar, desarmar, activar dispositivos y conocer el estado

del sistema. Al ser bidireccional, permite que cada comando que se envía al panel

reciba una respuesta del estado desde el mismo, indicando al usuario dicho estado

por medio de un código de colores del LED. Para mayor seguridad, los comandos se

pueden de¿nir para tener que activarse con un código PIN de 4 dígitos.

Consulte con su instalador las de¿niciones del mando.

Status BUZZER Indications:

Sound Status

1 beep Con¿rmation

3 beep Error

5 beep Alarm

Agility Wireless

2-Way Remote Control

4\?

Pour les instructions complètes d’installation, reportez vous à notre site web

www.riscogroup.com

Fonctions basiques:

Fonction Rapide Séquence avec code

Armement total > Code

Armement partiel* > Code

Désarmement (total) > Code

Etat du système Appui long Appui long > Code

Contrôle de sortie A/B/C

/ / /

Appui long Appui long > Code

Alarme panique + simultanément pendant 2 secondes

Annuler commande >

LED:

Fonction 1

ère

LED* 2

ème

LED*

(Envoie de commande) (Réception de l’état)

Armée totalement Verte Rouge

Armée partiellement Verte Orange

Désarmée Verte Verte

Alarme Verte LED rouges clignotante

BUZZER:

Son Etat

1 bip Con¿rmation

3 bips Echec commande

5 bips Alarme

4\?

Operaciones habituales:

Función Rápido Secuencia con código

Armado Total > Código

Armado Parcial

* > Código

Desarmado Total > Código

RISCO Group and its subsidiaries and af¿liates ("Seller") warrants its products to be free from defects in

materials and workmanship under normal use for 24 months from the date of production. Because Seller

does not install or connect the product and because the product may be used in conjunction with products

not manufactured by the Seller, Seller cannot guarantee the performance of the security system which uses

this product. Seller's obligation and liability under this warranty is expressly limited to repairing and replacing,

at Seller's option, within a reasonable time after the date of delivery, any product not meeting the speci¿cations.

Seller makes no other warranty, expressed or implied, and makes no warranty of merchantability or of ¿tness

for any particular purpose.In no case shall seller be liable for any consequential or incidental damages for breach

of this or any other warranty, expressed or implied, or upon any other basis of liability whatsoever. Seller's

obligation under this warranty shall not include any transportation charges or costs of installation or any liability

for direct, indirect, or consequential damages or delay. Seller does not represent that its product may not be

compromised or circumvented; that the product will prevent any personal injury or property loss by burglary,

robbery, ¿re or otherwise; or that the product will in all cases provide adequate warning or protection. Buyer

understands that a properly installed and maintained alarm may only reduce the risk of burglary, robbery or fire

without warning, but is not insurance or a guaranty that such event will not occur or that there will be no personal

injury or property loss as a result thereof. Consequently seller shall have no liability for any personal Minjury,

property damage or loss based on a claim that the product fails to give warning. However, if seller is held liable,

whether directly or indirectly, for any loss or damage arising under this limited warranty or otherwise, regardless

of cause or origin, seller's maximum liability shall not exceed the purchase price of the product, Mwhich shall

be complete and exclusive remedy against seller. No employee or representative of Seller is authorized to

change this warranty in any way or grant any other warranty.

WARNING: This product should be tested at least once a week.

CAUTION: risk of explosion if battery is replaced by an incorrect type.

Dispose of used batteriess according to local regulations.

FCC Note:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

a) Reorient or relocate the receiving antenna.

b) Increase the separation between the equipment and receiver.

c) Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

d) Consult the dealer or an experienced radio/TV technician.

FCC ID: JE4RW132KF2

IC: 6564A-RW132KF2

This device complies with FCC rules part 15. Operation is subject to the following two condition:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

FCC Warning

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modi¿-

cations to this equipment. Such modi¿cations could void the user's authority to operate the equipment.

* Si la 1ère LED est orange, cela indique une condition de batterie basse pour la télécommande.

* For Part Setting with no entry delay press the key for two seconds.

Pour l’armement partiel sans délai d’entrée, appuyez sur la touche pendant deux secondes.

[France only]:

Déclaration de conformité

Par la présente, RISCO Group déclare que la série Agility des centrales et accessoires a été

conçue conformément aux normes:

RTC 50131-3 ,EN50131-3, Grade 2

EN50130-5, Environmental class II (IP31, IK 06)

EN50131-6, Type C

Organisme de certi¿cation

AFNOR CERTIFICATION: 11 rue Francis de Pressensé

93571 LA PLAINE SAINT-DENIS Cedex, http://www.marque-nf.com

CNPP Cert: BP 2265, 27950 ST MARCEL, http://www.cnpp.com

Déclaration de Conformité RTTE

Par la présente, RISCO Group déclare que cet accessoire est en conformité avec les conditions

essentielles et à d’autres dispositions appropriées de la directive 1999/5/EC. Pour obtenir la

copie complète de conformité, référez-vous à notre site web : www.riscogroup.com

Ce produit répond aux exigences du référentiel de certi¿cation NF324-H58 pour la

classi¿cation 2 boucliers, et de la RTC 50131-3.

1 2

Summary of Contents

Page 1 - 2-Way Remote Control

ENGLISHFRANÇAISIntroductionThe Agility 2-Way remote control is an 8 button rolling code wireless transmitter designedfor remote system operation. The

Page 2 - ITALIANO

ITALIANODUTCH* Si el LED 1º cambia a naranja, indica batería baja del mando.Función LED 1º * LED 2º *

Comments to this Manuals

No comments

Risco-group 2-Button Panic Keyfob , 2-way User Manual

Browse online or download User Manual for Remote control Risco-group 2-Button Panic Keyfob , 2-way. RISCO Group 2-Button Panic Keyfob , 2-way User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Remote control Risco-group 2-Button Panic Keyfob , 2-way